Version of ais/ai-00057.txt

Unformatted version of ais/ai-00057.txt version
Other versions for file ais/ai-00057.txt

!standard A.10.1 (21)          95-11-01 AI95-00057/02
!class binding interpretation 95-06-25
!status WG9 approved 95-06-14
!status ARG approved 10-0-0 95-11-01
!status received 95-06-25
!subject Text_IO.Flush should use IN mode
!summary 95-06-25
The mode of the parameter of Text_IO.Flush is 'in' (not 'in out'). The same is true of Streams.Stream_IO.Flush.
!question 95-06-25
A.10.1(21) shows the parameter of Text_IO.Flush as mode 'in out'. This makes it impossible to Flush Standard_Output. Is this the intent? (No.)
!recommendation 95-06-25
The parameter mode of Text_IO.Flush and Stream_IO.Flush is 'in' (not 'in out', as shown in the RM).
!wording 95-06-25
!discussion 95-06-25
It is important to be able to call Flush on the Current_Output, Standard_Output, Current_Error, and Standard_Error files. However, these files are only accessible via function results or dereferencing an access-to-constant value; thus they cannot be Flushed if the mode is 'in out'.
Note that Current_Output is flushed by the parameterless Flush procedure (see A.10.3(21)); thus it had better make sense to flush Current_Output.
Therefore, we make the mode of the parameter of Flush be 'in'. This is consistent with procedures like Put, which also modify the file; a level of indirection is presumed in the implementation.
For consistency, the same applies to Stream_IO.Flush (see A.12.1(25)).

!section A.10.1(21)
!section A.10.3(20)
!subject Text_IO.Flush should use IN mode
!reference RM95-A.10.1(21)
!reference RM95-A.10.3(20)
!from Tucker Taft 95-06-23
!reference as: 95-5166.a Tucker Taft 95-6-23>>

The parameter mode of Text_IO.Flush should be IN
rather than IN OUT, given that Put uses IN mode,
and given that File_Access is access-to-constant.

This was pointed out by Dan Johnston (
on comp.lang.ada.



Questions? Ask the ACAA Technical Agent